Niche Installation

Even the most basic construction techniques with the simplest tools
are and can be inherently dangerous causing injury, bodily harm,
even death. If you are not completely comfortable and aware of all
the standard safety practices involved with the operation and use
of any tool (Power or Hand) use a licensed contractor who is.

Go to printable page

Step 1:

Once you have chosen your site, consider the following:
1. Any wiring such as switches and receptacles on either side of the wall.
2. Any vent pipes, plumbing or duct work that may be hidden in the wall

Step 2:

Locate your wall studs. This will determine placement of your niche

Step 3:

Establish your rough opening height and width depending on the outside perimeter
of the back side of your niche. Mark the wall and cut out the drywall along the wall
stud, use a level to mark your horizontal cut lines.

Colorado Niche Company assumes no responsibility
for damage done to niche or property by the installer

Step 4:

Dry fit and remove any drywall that is necessary. Use caulk or construction
adhesive on the edge of the rough opening.
Do not exceed 1/2" from the cut line

Step 5:

Set your niche and allow the adhesive to dry

Step 6:

Caulk in edge of the face frame and wipe clean with a damp rag
Please Note: Wine and magazine racks require screws (included and pre-drilled)
inside into studs to handle the added weight  and stress

Back to top